Switch²

The Dr. Dabber Switch² heats by induction: it is not a heating wire that gets hot but the quartz insert itself – contact-free, through a magnetic field. An infrared sensor continuously measures the actual temperature in the bucket and adjusts.

Features

• Induction heating with a titanium induction chamber
• 20 mm quartz insert, swappable for sapphire
• Infrared sensor reads bucket temperature in real time
• Degree-precise temperature control from about 121 °C to 343 °C
• Ready to use in 15 to 25 seconds
• 3000 mAh battery – about 17 to 25 sessions
• 36 W fast charger, full in 60 to 90 minutes
• Pass-through charging while in use
• App connection for custom heat profiles

Induction instead of a heating wire

With induction a coil creates a magnetic field that heats the insert itself – without any heating element touching it. That has two advantages: there is no component that wears out or burns, and the heat arises exactly where the concentrate sits. The insert rests in a titanium chamber with the coil fully built in.

The infrared sensor

A built-in infrared sensor continuously reads the bucket's temperature – like a laser thermometer inside the device. If it deviates from the target, the Switch² adjusts immediately. Instead of an estimated temperature you get the actual one, throughout the entire session.

Quartz or sapphire

A 20 mm quartz insert comes fitted. Anyone wanting more heat retention switches to sapphire: the material holds heat longer and releases it more evenly, which favours flavour especially at low temperatures. Both inserts are wear parts and available separately.

Battery and charging

The built-in 3000 mAh battery carries through about 17 to 25 sessions at typical settings. The supplied 36 watt adapter charges it fully in 60 to 90 minutes; the device can be used while charging.

How to use it

1. Take off the glass attachment and check the quartz insert.
2. Switch the device on and select the temperature.
3. Let it heat for 15 to 25 seconds.
4. Place concentrate in the hot bucket, put on the carb cap and draw.
5. Wipe out the bucket with a cotton swab once cool.