Pocket 2

The Yocan Pocket 2 is a portable vaporizer for concentrates and waxes. The Cloud 3 chamber is made entirely of ceramic and heats all round – with no wick and no cotton, which benefits flavour and service life.

Features

• Cloud 3 chamber of pure ceramic with 360° heating
• Degree-precise temperature control from 204 °C to 304 °C
• Up to 15 sessions per charge
• Angled mouthpiece with splash guard and attached cap
• Included terp pearls spread the concentrate during the session
• Haptic feedback when ready to use
• Aluminium alloy housing
• USB-C port, charged in about 1.5 hours

Ceramic chamber with all-round heating

The Cloud 3 chamber is a ceramic bucket that heats across its entire inner surface rather than through a single coil. That spreads heat evenly, prevents localised overheating and is gentle on terpenes. Because there is neither wick nor cotton, there is no flavour of its own and no regular coil replacement.

Temperature for concentrates

The working range runs from 204 °C to 304 °C and adjusts to the degree. At the lower end aroma and terpenes are preserved, towards 280 °C and above the vapour becomes noticeably denser. For a start the middle range is recommended – then upwards in small steps.

Terp pearls and mouthpiece

The supplied glass pearls move inside the chamber and spread the concentrate across the hot surface so that less residue stays at the bottom. The angled mouthpiece holds back with a splash guard what can boil up with concentrates; the attached cap stays on the device and won't get lost on the go.

Battery, housing and care

The battery carries up to 15 sessions and charges via USB-C in around one and a half hours. The aluminium alloy housing is built for mobile use. To clean, wipe out the still-warm chamber with a cotton swab – that is when residue comes off most easily.

How to use it

1. Flip open the cap and take off the mouthpiece.
2. Place a small amount of concentrate into the ceramic chamber using the dab tool.
3. Put the mouthpiece back on, switch the device on and select the temperature.
4. Draw slowly after the haptic signal.
5. Wipe out the chamber with a cotton swab while still warm.